
Most used mowers are fine. The ones that aren’t usually give themselves away within ten minutes in the seller’s driveway, as long as you know where to look and nobody warms the engine up before you get there.
Bring a flashlight and a rag, and plan on a short test cut before any money changes hands.
And go in knowing the price you’d walk away at. It’s a lot easier to say no in the driveway when you decided it at home.
Start With Hours, Not Years
Mowers wear out by hours, not birthdays. A basic walk-behind with a simple splash-lubricated engine has roughly 500 to 1,000 hours in it. A budget residential mower can be near the end of its life at 450 to 500 hours. A good residential riding mower is built for about 1,000 to 1,500.
A typical homeowner puts around 30 hours a year on a mower. So a five-year-old push mower that cut one ordinary lawn is barely broken in. One that cut three lawns a week for a side business is a very different machine.
Riding mowers usually have an hour meter. Push mowers almost never do, so you’re estimating from the size of the lawn it cut and how often.
Judge the number against that machine’s range, not against one magic figure. A few hundred hours is most of the life of a cheap residential mower but well under half the life of a good one. And a mower serviced on schedule tends to reach the top of its range. A neglected one, the bottom.
Questions to Ask Before You Drive Over
A two-minute phone call saves a wasted trip, so make it before you drive anywhere.
- How many hours, or how many seasons on how big a lawn?
- When was the oil last changed?
- Did it sit over the winter with gas in the tank?
- Has it been tipped on its side lately?
- Do you still have the owner’s manual?
- Why are you selling it?
The oil answer tells you a lot. The usual interval is every 50 hours or once a season, whichever comes first. A seller who can name the last change usually kept up with the rest of it too.
The gas answer matters almost as much. Untreated gas starts to break down after about a month, and ethanol blends pull in water and leave gum behind in the carburetor and fuel lines. Stale gas is the most common reason small engines won’t start or run right. So a mower that sat all winter on old gas may only need a fuel change and a carburetor cleaning. But price that in.
Then ask one more thing: please don’t start it before I get there.
The Cold Start
A cold engine tells the truth. A warm one hides hard starting, so the first start of the day is the one you want to see.
Before anybody pulls the cord, pull the dipstick. Oil should be checked with the engine cold, which is exactly when you’ve got it. Look at the level, and look at the oil itself.
Then let the seller start it. It should catch within a few pulls (or a few seconds of cranking on a rider) and settle into a steady idle. Hard starting can come from stale gas, a dirty or fouled spark plug, a gummed-up carburetor or low compression. The first couple are cheap fixes.
Low compression isn’t.
While it runs, look at the cooling fins around the engine. Most mower engines are air-cooled, and fins packed with dried clippings make the engine run hot, which thins the oil and cooks the seals. A crusty engine shroud says something about how the rest of the machine was kept.
On a riding mower, look for an oil filter on the engine. Cheaper engines splash oil around with a dipper inside the crankcase. Better ones have a real oil pump and a filter, like a car, so a filter is a good hint about which kind you’re buying.
Read the Smoke
A little puff at startup isn’t the verdict. Steady smoke after it warms up is.
Blue or white smoke means the engine is burning oil. There are innocent reasons. The mower may have been tipped on its side for a blade change or to fit in a car, which lets oil get where it shouldn’t. It may have been run on a slope steeper than 15 degrees. Or the crankcase is simply overfilled, and the dipstick will show that.
Worn piston rings or a damaged cylinder can cause the same smoke, and that’s an engine job and a good reason to walk away.
Black smoke means it’s running rich. A dirty air filter, bad gas, too much oil or a flooded carburetor can all do it. The air filter is the cheapest check first, so start there, and ask the seller when it was last changed.
If the seller says they tipped it to clean the deck that morning, fair enough. Let it run a while and watch whether the blue clears.
The Deck and the Blade

Pull the spark plug wire before your hands go anywhere near the blade. Every time, no exceptions. When the mower has to be tipped, tip it with the spark plug facing up so oil stays in the crankcase.
Look at the top of the deck first, then underneath. Surface rust is cosmetic. Rust that has eaten holes through the deck, or flakes away when you press on it, means a deck near the end, and on a push mower the deck pretty much is the mower.
Then the blade. Blades last roughly 100 to 200 hours with normal sharpening, so a dull one on a used mower is normal and cheap to fix. A bent one is a different story. It shakes the whole deck, and a blade that hit something hard enough to bend may have bent the shaft too. If the deck shakes on the test run, our guide to why a mower deck vibrates walks through what to check.
On a walk-behind, test the blade brake. New walk-behind rotary mowers have to stop the blade within 3 seconds after you let go of the control. With the mower running on the ground and you standing behind the handle, let go and listen. If the blade keeps spinning well past that, the brake or its cable needs work before anyone mows with it.
Riding Mowers: Belts, Battery and the Drive

A rider has more to check, and more that’s expensive. The good news is that small stuff like a battery, a spark plug or the belt is almost always worth fixing.
Ask how old the battery is. A lead-acid mower battery usually lasts about 3 to 4 years, so a four-year-old battery is a fair thing to knock off the price.
Look at the belt where you can see it. Cracks and fraying mean it’s due, and that’s a cheap part.
The drive is the part that isn’t cheap. Engine and hydraulic trouble are where repair bills get big, so drive it forward and back, and try it with the deck engaged. A transmission that hesitates or slips under load is worth a hard look. If it’s a hydrostatic drive, ask when its fluid was last changed (the owner’s manual will say how often it should be).
For what a rider is actually worth by brand, age and hours, our used riding lawn mower values guide has the numbers.
Mow a Strip Before You Pay

Ask to mow a strip of the seller’s lawn. It shows what a driveway check can’t.
Watch the cut first. Even height across the deck is what you want. A ragged or uneven strip points to a dull or bent blade, or a deck that’s out of level.
Listen to the engine when it hits thicker grass. A healthy engine dips a little and recovers. One that bogs down and struggles to come back has less left in it.
On a self-propelled mower, let go of the effort and see if it pulls on its own. Plus check that it stops pulling when you release the drive lever.
Buy It, Haggle or Walk Away

A mower that starts cold, runs without steady smoke and has a blade that stops on time is worth a fair price. Anything small it needs is fair game for haggling: blades, a spark plug, filters, a battery or a belt. A plug is due about every 100 hours, and the filters go with each oil change, so a seller who skipped those has handed you a discount.
Walk away from blue smoke that won’t clear, a deck rusted through, or a riding mower whose drive slips. Those are the expensive repairs. The closer a mower sits to the end of its hour range, the more a big repair points toward buying something else instead.
If you’re shopping on a tight budget, our list of used lawn mowers for sale under $500 is a good place to start looking. Then take this list with you to the driveway.